ZRF-HTP-0015 tables and figures

The tables this deliverable needs, where each one's data comes from, and which cannot be filled.

Demonstration project - no figure here describes a real facilityChanges are not saved

Why

A table is reported as fillable only when the register it draws from is a source document on this deliverable. Nothing is generated.

Writes are validated against the engineering rules and then refused, because no database has been configured for this environment.

Tables required

Fillable

Missing their source

Rows that cannot be stated

Figures required

A table with a hole in it is worse than no table

A generated table missing rows looks complete. Somebody reads it, counts the lines and plans a hydrotest around them. So a table whose source the deliverable does not hold is reported as not fillable rather than produced short.

Tables

Each one's row count is the register's own, scoped to this deliverable. Open a table to see the rows it would carry.

Tables required by this deliverable
Table	What it needs	From	Rows available	Cannot be stated
Test pressures by line	the line list, with design and test pressures	ZRF-REG-LL-001	1	1	Short by 1
Equipment under test	the equipment register, scoped to the test pack	ZRF-REG-EQ-001 not a source	none	—	Source not held
Instruments to be isolated	the instrument index, scoped to the test pack	ZRF-REG-II-001 not a source	none	—	Source not held
Valve positions for the test	the valve register, with fail positions	ZRF-REG-VR-001 not a source	none	—	Source not held

Test pressures by line

The rows this table would carry, drawn from ZRF-REG-LL-001 and scoped to this deliverable.

Test pressures by line rows
Tag	Description	Unit
12-CD-1203-100-A1A	Surge drum level control line	U-12	Unverified

1 row cannot be stated

Carried here rather than dropped. A table that silently omitted these would be short by 1 line and look complete, and somebody would plan a hydrotest around the lines that are there.

12-CD-1201-150-A1A
The pump datasheet rates P-1201A at 24 barg and the line list rates its discharge line 12-CD-1201-150-A1A at 26 barg. Both cannot be the design intent for one connected system, and which is right decides the hydrotest pressure.

Figures

Figures required
Figure	What it needs
Test pack boundary marked up	the P&ID with the boundary confirmed	Placeholder only
Isolation schematic	the P&ID and the confirmed isolation list	Placeholder only

A figure is a placeholder, with its caption and source named. Why