ZRF-ITP-0003 tables and figures
The tables this deliverable needs, where each one's data comes from, and which cannot be filled.
Demonstration project - no figure here describes a real facilityChanges are not saved
Why
A table is reported as fillable only when the register it draws from is a source document on this deliverable. Nothing is generated.
Writes are validated against the engineering rules and then refused, because no database has been configured for this environment.
Tables required
4
Fillable
0
Missing their source
4
Rows that cannot be stated
0
Figures required
2
A table with a hole in it is worse than no table
A generated table missing rows looks complete. Somebody reads it, counts the lines and plans a hydrotest around them. So a table whose source the deliverable does not hold is reported as not fillable rather than produced short.
Tables
Each one's row count is the register's own, scoped to this deliverable. Open a table to see the rows it would carry.
| Table | What it needs | From | Rows available | Cannot be stated | |
|---|---|---|---|---|---|
| Test pressures by line | the line list, with design and test pressures | ZRF-REG-LL-001 not a source | none | — | Source not held |
| Equipment under test | the equipment register, scoped to the test pack | ZRF-REG-EQ-001 not a source | none | — | Source not held |
| Instruments to be isolated | the instrument index, scoped to the test pack | ZRF-REG-II-001 not a source | none | — | Source not held |
| Valve positions for the test | the valve register, with fail positions | ZRF-REG-VR-001 not a source | none | — | Source not held |
Figures
| Figure | What it needs | |
|---|---|---|
| Test pack boundary marked up | the P&ID with the boundary confirmed | Placeholder only |
| Isolation schematic | the P&ID and the confirmed isolation list | Placeholder only |
A figure is a placeholder, with its caption and source named. Why